Publicité
3: VEHICLE WITH REAR AIR DUCT ONLY
1: HOOKS
2: CENTER AIR DUCT
1: AIRBAG HARNESS
3: FRONT
4: FRONT
3: ACCELERATOR
PEDAL HARNESS
1: HOOKS
A029425
3: FRONT
4: ORIGINAL
BOLTS
(DISCARD)
2: AIRBAG ECU
2: AIRBAG ECU
1: HEATER UNIT LOWER CASE
(o) Center air duct
(p) Airbag ECU
WARNING
1. Before starting work always check the cautions
and warnings for the SRS airbag system.
2. Make sure the ignition switch is OFF (LOCK)
position.
3. Make sure the negative terminal is removed
from the battery.
4. If installing airbag sensor assy CTR without
disconnecting the negative terminal of battery,
airbag may open if there is an impact on it.
Make sure that the negative terminal of battery
is disconnected before installation.
5. Wait at least 90 seconds after negative terminal
is disconnected to start installation.
6. Do not disconnect the airbag harness from the
airbag ECU, when removing the airbag ECU.
7. Put down the airbag ECU in a way that
minimizes the force on the airbag harness.
8. Do not subject the airbag sensor to any shocks
or force.
A009247
(q) Two screws (for heater unit lower case)
WARNING
When removing the screws, ensure that the screws
do not interfere the accelerator pedal harness. (If
the accelerator pedal harness is interfere, the
vehicle harness may be damaged.)
A029307
- 21 -
00503438E
Publicité
