Establishing The Electrical Connection En - Abicor Binzel BRS-CC Mode D'emploi

6 Putting into operation
6.9 Establishing the electrical connection
Four 24 V DC robot outputs and one 24 V DC robot input are required to control the valves.
NOTE
• The prism must match the diameter of the gas nozzle.
• The distance sleeve must match the nominal diameter of the gas nozzle.
• The reamer must be precisely aligned with the torch type.
Fig. 12
EN - 18
lmax < 200 mA
lmax < 200 mA
lmax < 200 mA
lmax < 200 mA
lmax < 200 mA
24 V DC
GND
Electrical connection
Injection
Lift
Cutter
Valves: clamp, motor
Signals: Lift down
BRS-CC