Mounting The Reamer En; Setting Up The Clamping Position En - Abicor Binzel BRS-CC Mode D'emploi

6 Putting into operation
6.6 Mounting the reamer
1 Clamping device
Fig. 9 Mounting the reamer
NOTE
• When changing the reamer, only use tools with a suitable width across flats.
1 Put the reamer (2) along with the reamer seat.
2 Secure the reamer (2) (min. 20 Nm).
6.7 Setting up the clamping position
1 Gas nozzle
Fig. 10 Setting up the clamping position
 Fig. 6 on page EN-13
1 Move the torch with the gas nozzle (1) vertically to the tool axis (reamer axis) over the
BRS-CC (3) (P1).
2 Approach the clamping position (P2). Make sure that the cylindrical part of the gas nozzle (1) lies evenly
against the prism (2).
EN - 16
1
eamer
2 R
Reamer seat AF 27 mm, reamer AF 17 mm
1
2 Prism
2
3
3 Tool
2
3
3 BRS-CC torch cleaning station
BRS-CC