Pulsar ACCOLADE 2 LRF XP50 PRO Mode D'emploi page 6

Connect the micro USB plug of the USB cable (12) to the micro USB port (13)
•
of the charger.
Connect the other end of the microUSB cable to the mains adapter (14).
•
Plug the mains adapter (14) into a 100 - 240 V socket (15).
•
• Disconnect the charger from the mains after the battery is fully charged
(green LED light stays on continuously).
Battery Pack
9
Installing Battery Pack into the Device
Lift up the lever (16).
•
Remove the battery (9) from the
•
charging pad.
Insert the battery (9) as far as it will
•
go into the slot of the device body
designed for it so that the F part is at
the bottom.
Lock the battery (9) by lowering the
•
lever (16).
3
ENGLISH
Lever LED Indicator
11
USB cable
Mains adapter
Green LED light stays on
continuously – battery is full
Blinking red LED light –
battery is empty
Micro
13
USB port
12
14
Network
15
9 16
F