Customizing The Installation - Basic Menu - Key Automation CT-724 Instructions Et Avertissements Pour L'installation Et L'usage

SELF-LEARNING OF THE TRAVEL AND MAIN PARAMETERS
1. Unlock the gate, door or barrier, bring it to a central position and lock it again
2. Press buttons + and MENU SIMULTANEOUSLY for more than 5 seconds and get ready to press (if
necessary) the DOWN button (see figure)
3. If the first maneuver is NOT an opening, press DOWN to stop the self-learning.
Then press PP in order to restart the acquisition: the gate starts to move towards the correct direction
4. Wait until two complete maneuvers are carried out (2 openings and 2 closings) and the gate ends
the travel in the closed position
5. Perform a few opening, closing and sudden stop operations, verifying that the installation is solid
and there are no installation defects.
All the main parameters are initially set up by the control unit. To customize the installation proceed with the next paragraph.

4.4 - Customizing the installation - BASIC MENU

If necessary, you can select a BASIC MENU that allows you to
change the basic parameters of the unit. To select the BASIC MENU
follow the steps below.
Example of changing a BASIC MENU parameter
UP DOWN
MENU
Hold down the MENU button
for 1 second to enter the ba-
sic menu
UP DOWN
MENU
Hold down the MENU button
for 1 second until it stops flash-
ing to save the changed value
or press MENU quickly to exit
without saving
PARAMETERS
1
Automatic reclosing time
2 Reclosing time after transit (0 = disabled)
Motor sensitivity, sensitivity to obstacles.
( 1 = lowest sensitivity, maximum force on the obstacle
3
10 = maximum sensitivity, minimum force on the
obstacle)
4
Nominal motor speed
5 Decelerating motor speed
PP Configuration
0.
1.
6
2.
3.
4.
Behavior of the automation after a black out
0.
7
1.
2.
Energy savings: enables accessories to turn off with
the gate closed (max consumption 40 mA)
8
0.
1.
UP DOWN
MENU
Once in the BASIC MENU,
press + and - buttons to scroll
through the functions
UP DOWN
MENU
Once in the BASIC MENU,
press + and - buttons to
scroll through the functions
and modify other parameters.
DESCRIPTION
(0 = disabled)
Normal (OP-ST-CL-ST OP-ST-CL-ST ...)
Alternated STOP (OP-ST-CL OP-ST-CL ...)
Alternated (OP-CL OP-CL ...)
Condominium or timer
Condominium with immediate reclosing
No action, remains as it was
Closing
Completing the last maneuver
Function disabled
Function enabled
CAUTION: To view the status defined as "NORMAL OPERATION",
which is the starting point for accessing the BASIC MENU, press
"MENU" two times
UP DOWN
MENU
To change a value, hold down
the MENU button for 1 second
until the value stops flashing
UP DOWN
MENU
Press the MENU button quickly
to exit the menu
DEFAULT MIN
20 0
0 0
3 1
4 (6*) 1
3 (2*) 1
0 0
0 0
0 0
UP DOWN
MENU
PP
UP DOWN
MENU
Press the + and - buttons to
modify the value which is flash-
ing
MAX UNIT
900 s
30 s
10
10
8 (3*)
4
2
1
EN
21