stayer OLMO G-1 250 C Instructions D'emploi page 28

gb
Trouble shooting
Malfunction
The saw chain does not
move
The engine
not start or only with
difficulty
Difficulties at hot starts
The engine starts but
stalls immediately
lnsufficient power
No saw chain lubrication Oil pump/tank
System
Saw chain brake
does lgnition system
Fuel delivery
Sistema de
compressione
M e c h a n i c a l
malfunction
Carburetor
Fuel delivery
Several systems
may be involved
simultaneously
Remark Cause
The engine works The saw chain brake is activated
lgnition spark Malfunction of the fuel delivery system,
compression system or mechanical
malfunction.
The switch is on "STOP", failure or short
There is no ignition circuit in the cabling, spark plug cap or
spark faulty spark plug.
The fuel tank is full Estrangulador en posición incorrecta,
carburador defectuoso, cabeza de succión
sucia, conducto de combustible doblado o
interrumpido.
lnside Sump seal faulty, packaging of the radial
axles faulty, cylinder or piston rings faulty.
Outside The spark plug does not close hermetically.
The starter does not The spring of the starter is broken, broken
actuate pieces inside the engine.
The fuel tank is full lncorrect adjustment of the carburetor.
lgnition spark
The fuel tank is full lncorrect idling adjustment, suction head or
carburetor dirty. Ventilation of the
tank faulty, fuel pipe interrupted, faulty
cable, faulty STOP switch.
The engine is idling Air filler dirty, incorrect adjustment of
the carburetor, muffler clogged, exhaust
channel of the cylinder clogged.
There is no oil on the Oil tank empty.
saw chain Oil guide slot dirty.
/ /
28