stayer LOM130PD Instructions D'emploi page 8

1 Lever
2 Clamper
3 Punch plate
4 Abrasive paper
5 Guide
SPECIFICATIONS
Model LOM130PD (170 W)
Pad size
Orbits per minute
Net weight
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for the sanding of large surface of wood,
plastics and metal materials as well as painted surfaces.
Power supply
The tool should be connected only to a power supply of the same
voltage as indicated on the nameplate, and can only be operated
on single-phase AC supply. They are double-insulated in
accordance with European Standard and can, therefore, also be
used from sockets without earth wire.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.
ADDITIONAL SAFETY RULES
ENB042-3
1. Hold the tool firmly.
2. Do not leave the tool running. Operate the tool only when hand-
held.
3. This tool has not been waterproofed, so do not use water on the
workpiece surface.
4. Ventilate your work area adequately when you perform sanding
operations.
5. Some material contains chemicals which may be toxic. Take
caution to prevent working dust inhalation and skin contact.
Follow material supplier safety data.
6. Always use the correct dust mask/respirator for the material
and application you are working with.
SAVE THESE INSTRUCTIONS.
OPERATING INSTRUCTIONS
Attaching abrasive paper
CAUTION:
Always be sure that the tool is switched off and unplugged before
installing or removing the paper.
ENGLISH
8
Explanation of general view
6 Velcro sandpaper
7 Base
8 Plate
9 Tube powder collector
10 Suction port
85 mm × 135 mm
8
85 mm × 200 mm
-1
14.000 min
1.2 kg
Model (Fig. 1 & 2)
Raise the lever. Insert the paper end into the clamper, aligning the
paper edges even and parallel with the sides of the base.
(Prebending the paper makes attachment easier). Once the paper
is in place, return the lever to its original position.
Repeat the same process for the other end of the base,
maintaining the proper paper tension.
CAUTION:
After inserting the paper, make sure the teeth of the clamper hold it
securely. Otherwise the paper will be loose and subject to
slippage, resulting in uneven sanding operation.
Models (Fig. 3, 4 & 6)
Important:
Use Stayer hook-and-loop sandpaper with this sander.
To attach the sandpaper:
1. Set the tool upside down so that the pad is on top.
2. Position the sandpaper to fit the shape of the base. Be sure to
align the holes on the sandpaper with the holes on the pad (the
dust will be sucked into these holes; it is therefore important to
leave them open).
3. Press the paper firmly over the pad.
11 Entry port
12 Protrusion
13 Dust spout
14 Switch
89 mm × 225 mm