Bercomac 700450 Manuel Du Propriétaire page 4

BELT INSTALLATION ON COMPACT SUBFRAME
Install the belt on the drive mechanism pulley (item 4).
Make sure the belt is routed as shown.
TIP: Because of strong tension on the spring and to
facilitate installation of the belt, the broom must be on
the ground and belt removed from the engine pulley.
Push the handle of the idler arm (item 1) toward the
right to release tension on the belt and install belt on
the tension pulleys.
Then install belt on the broom pulley as shown .
CAUTION
Never use the Rotary Broom without the belt
guard.
ASSEMBLY
NEVER OPERATE THE ROTARY BROOM
Brush hood
Belt guard
Gear box guard
Extension guard and any other safety protection
devices in place.
Install belt
1. Broom pulley
2. Idler
3. Flat pulley
4. Drive mechanism pulley
2
DANGER
WITHOUT:
Push handle to release tension on belt