Bercomac 700450 Manuel Du Propriétaire page 3

Please follow these adaptor installation
instructions on the Rotary Broom. For all
other instructions see the Owner's Manual
for the Subframe and the Rotary Broom for
all safety precautions and rules.
See parts breakdown for part identification
STEP 1
ADAPTOR INSTALLATION
Remove the belt guard (item 6).
Install the push frame (item 1) to the gear box frame
(item 2) by using two cone bearings (item 3), one on
top and the other underneath. Fill the space between
the bearings with grease.
Secure with a seal washer (item 4), the hollow portion
toward the top and a 3/4" nylon insert lock nut (item
5).
Tighten loosely enough to permit the push frame to
move freely.
Push the handle end (item 8) to the right to release
the tension on the idler arm and install the V-belt on
the tension pulleys (item 7). Then, install the belt on
the broom pulley as shown.
Reinstall the belt guard (item 6) on the push frame
STEP 2
ROTARY BROOM INSTALLATION
WARNING
TO PREVENT INJURIES:
Stop the motor.
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
Attach the rotary broom to the subframe as shown.
Make sure the rotary broom is pushed in until locked
into place by the springs (item 1).
ASSEMBLY
NEVER OPERATE THE ROTARY BROOM
Brush hood
Belt guard
Gear box guard
Extension guard and any other safety protection
devices in place.
1
DANGER
WITHOUT:
Install broom adaptor
Install Rotary Broom