WAGNER D GB F NL I CONTROL 150 M Traduction Du Mode D'emploi Original page 26

GB
Make pump ready for operation
1) Make sure the inlet filter is in
place inside the hopper. If it
is not, snap in place as shown.
2) Press down the button on the
filter once. This will ensure
proper operation of the inlet
valve.
We recommend performing the following steps with
water first of all, in order to check that the system and all
connections are watertight.
3) Fill your hopper with the
material you plan to spray.
Do not exceed the fill line as
shown.
4) Turn the PRIME/SPRAY knob
to PRIME.
5) Plug in the sprayer, and
move the ON/OFF switch to
the ON position.
6) Check that the material is
flowing through the return
tube.
7) Switch the pump to OFF.
Mount the cover during operation. The cover
i
does not close airtight. Therefore, do not tilt
the device when filled.
26
Preparation
Button
Fill line
Suck in material
Perform the following steps, without the spray tip
mounted to the gun.
1) Unlock the spray gun and
turn the PRIME/SPRAY knob
to PRIME.
2) Trigger and HOLD the spray
gun into a waste container.
3) Switch the pump on.
WARNING
Keep hands clear from fluid
stream.
4) While holding the trigger,
turn the PRIME/SPRAY knob
to SPRAY. Hold the trigger
until all air, water, or solvent
is purged from the spray hose
and paint is flowing freely.
5) Release trigger, turn the
PRIME/SPRAY knob to
PRIME and turn pump OFF .
6) Trigger the gun into the waste container once more to
be sure that no pressure is left in the hose.
7) Lock the spray gun off.
8) Thread the spray tip assembly onto the gun. Tighten by
hand.
9) Insert spray tip (tip pointing in the spray direction).
Your device is now ready for operation.
Control 150 M