WAGNER D GB F NL I CONTROL 150 M Traduction Du Mode D'emploi Original page 24

COMPONENTS AND ASSEMBLY
GB
Components
•
Spray gun with filter
•
Spray tip assembly
•
7.5 mtr. long
Tools needed for assembly
•
Two adjustable wrenches.
WARNING
Do not plug in the unit until setup is complete.
Inlet filter
(inside of hopper)
Spray hose
Tip guard
Assembly
1
Place the spray gun against the tapered end of the hose
and twist the gun onto the hose. Firmly tighten the
thread using a wrench
24
Hopper lid
Return tube
Hopper
Outlet valve
Tip Trigger
(311 and 515)
Controls and functions
ON/OFF switch
Spray Gun
Spray Hose
Return Tube
PRIME/SPRAY knob
PRIME/SPRAY knob
Spray gun
Trigger lock
Filter (white)
preassembled
in gun
2
Twist the thread at the other end of the hose onto the hose
connection. Using a wrench, hold the hose connection firmly and
tighten the hose with another wrench.
Control 150 M
The ON/OFF switch turns the unit
on and off (O = OFF, l = ON)
The spray gun controls the
delivery of the fluid being
pumped.
The spray hose connects the gun
to the pump.
Fluid is sent back out through the
return tube to the hopper when
priming.
The PRIME/SPRAY knob directs
fluid to the spray hose when set
to SPRAY, or the return tube when
set to PRIME.
ON/OFF Switch
Tip storage
Handle
Motor
housing
PRIME/SPRAY
ON/OFF
switch
Filter (red)
= ON
= OFF
knob
PRIME
Position
SPRAY
Position