Cardin S504 Serie Mode D'emploi page 11

433 MHz transmitters
TXQ504C2
TXQ504C4
TXQPRO504-4
TXQPRO504-4A
433 MHz receivers
RQM504C2
RSQ504C2
RSQ504OC2
RCQ504C1
Memory module ZGB24LC64-I/P
The module is furnished with a none-volatile EEPROM type memory and contains the transmitter codes and allows
you to memorise up to 1000 codes. The programmed codes remain stored even in the absence of power.
Attention! Removing and inserting the memory module must be carried out when the receiver is switched off
otherwise the memory content could become corrupt.
PREPARING THE SYSTEM
To obtain the best results from the radio control system the aerial installation site should be carefully chosen. 'Range'
is intended to mean the working distance, measured in free space, between the receiver and the transmitter with
the aerial installed. The range is therefore closely linked to the technical characteristics of the system and varies
according to the characteristics of the site in which the system is located. For best
to use the Cardin ANS400 / ANQ800-1 aerial. Wire the aerial to the receiver using a coaxial cable RG58
(impedance 50Ω) with a maximum length of 15 m.
868 MHz transmitters
TXQ508C2
TXQ508C4
TXQPRO508-4
TXQPRO508-4A
868 MHz receivers
RQM508C2
RSQ508C2
RSQ508OC2
RCQ508C1
11
Description
2-channel precoded transmitters
4-channel precoded transmitters
4-channel precoded industrial transmitters
4-channel precoded industrial transmitters + aerial
Description
2-channel mini receivers
2-channel slot-in receiver cards
2-channel slot-in receiver cards open collector
4-channel outdoor receivers
performance we advise you