Throttle Lever - EMAK CHEYENNE 92 Manuel D'utilisation Et D'entretien

(15) 12V socket
The 12V socket is located on the right side of the machine cover.

(16) Throttle lever

Serves to regulate the engine speed. It has the following three positions:
(17) By-pass lever – free movement of the rear wheels
The by-pass lever serves to disengage the transmission for the rear wheel drive and is used to push or
pull the machine without using the engine. The lever is located on the rear side of the machine and has
the following two positions:
ATTENTION! The by-pass lever is primarily used to bleed air from the hydrostatic system.
Due to the high demands on equipment, have this procedure performed by a specialised
service centre.
The machine must not be used (gear shifted into drive) if the by-pass lever is in the
disengaged position - there is a danger of damage to the transmissions!
The socket can, for example, be used for the following tasks:
- connecting/recharging a mobile telephone
- connecting a portable flashlight
MAX
MIN
Rear wheel
Position
drive
(0) DISENGAGED
(1) ENGAGED
Maximum engine speed
Minimum engine speed (idle)
Lever is extended - for pushing the machine
Lever is inserted - for driving the machine
81
Use