Selecting The Operation Mode - Makita AN924 Manuel D'instruction

Selecting the operation mode

CAUTION:
Always make sure that the actua-
tion mode selector is properly set to the position
for the desired nailing mode before nailing.
1
► 1. Actuation mode selector
Single sequential actuation mode:
You can drive one nail by one sequential operation.
Select this mode when driving a nail carefully and
accurately.
To choose this mode, set the actuation mode selector to
the position.
Contact actuation mode:
You can drive nails repetitively by placing the contact
element with the trigger held.
To choose this mode, set the actuation mode selector to
the position.
Single sequential actuation
CAUTION:
Do not place the contact element
against the workpiece with excessive force. Also,
pull the trigger fully and hold it on for 1-2 seconds
after nailing.
Even in the "Single sequential actuation" mode, half-
pulled trigger causes an unexpected nailing, when the
contact element re-contacts the workpiece.
Place the contact element against the workpiece and
pull the trigger fully.
After nailing, release the contact element, and then
release the trigger.
2
1
Contact actuation
Pull the trigger first and then place the contact element
against the workpiece.
2
Anti dry fire mechanism
This tool is equipped with an anti dry fire mechanism.
When there are a few nails remaining in the magazine,
the contact arm will be locked in the undepressed posi-
tion to prevent the tool from being activated. When it is
activated, load more nails to resume operation.
Removing jammed nails
CAUTION:
Always release the trigger and dis-
connect the hose before removing jammed nails.
CAUTION:
Do not use deformed nails or nail
strip. Failure to do so causes poor nail feeding.
When the nailer becomes jammed, do as follows:
Insert a small rod or the like into the ejection port and
tap it with a hammer to retract the driver.
1
► 1. Hammer 2. Small rod 3. Ejection port 4. Driver
8 ENGLISH
1
2
3
4