Tristar SZ-1915 Mode D'emploi page 4

instruction manual
PaRTS LiST
1. Suction hole
2. Holes for attaching the shoulder strap
3. On/off switch
4. Handle
5. Release button for the dust cup
6. Dust cup
7. Dust cup filter
8. Cleaning brush
9. Crevice brush
10. Plug
11. Flexible hose
12. Shoulder strap
aSSEmbLy
Warning. Always unplug from electrical outlet before opening the dust cup (6).
Note: Dust cup filter (7) must be used when operating the vacuum cleaner
1. Press the Release button (5) to open the dust cup (6) then pull out the dust
cup(6). Check if the filter (7) is placed after checking place the dust container
(6) back on the vacuum cleaner.
2. To attach the cleaning brush (8) or crevice brush (9) to the vacuum cleaner.
push brush into the suction hole (1).
3. To use the flexible hose (11), push the end of the hose into the suction hole (1),
then attach the desired brush (8 or 9) to the other end of the flexible hose (11).
How to operate your hand vacuum
1. Hold the vacuum cleaner firmly with your hand on the handle (4).
2. Push the On/Off Power switch (3) to "On" position.
3. Start vacuuming.
caution: The vacuum cleaner is a very powerful unit. Make sure that you hold it
firmly. Otherwise it can slip out of your hand and cause injury.
4
vacuum cleaner
5
4
3
2
2
1
6
8
12
9
11
cHaNgiNg & cLEaNiNg THE DuST cuP FiLTER
Warning: Always unplug from the electrical outlet before opening the dust cup (6).
1. To open the dust cup (6), push button (5) and pull out the dust cup (6).
10
2. Pull out the dust cup filter (7).
3. Empty the dust from the dust cup filter (7)
4. Rinse the dust cup filter (7) in cold water, and then wait until it dries
completely before replacing it into the dust cup (6).
5. Place the dust cup filter(7) carefully into the dust cup (6).
6. Attach the dust cup (6) to the hand vacuum.
7
important: Make sure that dust cup filter is completely dry before inserting
back in the vacuum cleaner.
TRoubLESHooTiNg guiDE
PRobLEm
HAND VACUUM WILL
NOT OPERATE
HAND VACUUM WILL
NOT PICK-UP OR
SUCTION POWER IS
WEAK
DUST ESCAPING FROM
HAND VACUUM
PoSSibLE REaSoN PoSSibLE SoLuTioN
1. Power cord not firmly 1. Plug unit firmly
plugged into outlet. 2. Check fuse or breaker.
2. No power in wall Replace fuse/reset
outlet breaker
1. Dust cup filter is full. 1. Empty dust cup filter
2. Unit clogged. 2. Turn unit off and
3. Dust cup filter needs unplug from wall
cleaning. outlet, Remove dust
cup filter and check
for object(s) in air
dust and remove.
3. Clean or replace dust
cup filter.
1. Dust cup filter is full. 1. Empty dust cup filter
2. Dust cup filter is not 2. Review dust cup filter
installed correctly instruction.
3. Puncture hole in dust 3. Replace dust cup
cup filter filter.