Monitor Audio PLW215II Guide De Configuration page 8

FrontPanel
1 2
UsingthePLW215II
PowerCycle
When woken up from standby by one of the below methods, all of the LED's will illuminate on the top, then fading off in a sequence
leaving only the volume trim level and selected preset number LED's illuminated. These will then fade to 10% or off, dependant on
the chosen settings. The fade settings can be set in the SubConnect application
WakingUp
There are a number of different ways that the PLW215 II becomes operational:
Remote: By pressing the standby button on the remote, the PLW215 II will wake from standby. When woken in this mode, the auto
turning off will function as normal. However, if the PLW215 II is turned off by the remote, it will only turn on at next use, by either
the control dial (see below) or by the remote. The auto signal sensing will be disabled.
Control Dial: When woken by pressing or turning the control dial, the PLW215 II will continue to remain on while a signal is present
or until the defined auto off time has been reached (default 20 minutes)
Signal Sense: This method is fully automatic. The PLW215 II will wake when it receives a signal on any of its inputs. It will then
go into standby after the defined period of time (default 20 minutes).
12v Trigger: This is a method of control by the AV receiver or amplifier. Whenever the source amplifier is turned on, the PLW215
II will wake. Likewise when the source amp is turned off, the PLW215 II will also turn off.
RS232: This method of control is defined by the home automation control. Further details on this method of control and the
programming can be found in the electronic manual on the USB stick in the tool box.
RoomEQ
The PLW215 II has a sophisticated room equalisation algorithm that detects any unwanted room modes and flattens them out to
give the most accurate bass response possible.
To carry out the room EQ, simply connect the supplied microphone to the input socket on the front of the PLW215 II (Item 1 above)
and place the microphone in the seating position. To get the most accurate response, point the mic up to the ceiling. The PLW215
II will run 2 sweeps by default, but this can be changed in the SubConnect application under Tools > Room Correction.
With the mic in the first position, press and hold the control dial (it can also be started within the application). It will count down by
illuminating the LED's and then flashing. When it flashes you can then release the dial. After the first sweep, there will be a pause
of about 20 seconds. In this time you can either move to a new location or leave it in the same location before a second sweep is
run. This pause can be cancelled by pressing the control dial again and the next sweep will start immediately.
If the sweep is run without the microphone connected an error code will be displayed, illuminating all LED's.
6
1. PLW215 II IR Receiver
Aim the PLW215 II remote here for it to function.
2. IR LED Indicator
Blinks when an IR signal is received.
3. Room EQ Set Up Microphone
3
Connect the supplied set up microphone here and run the set up
procedure detailed below.
PLW215 II