Monitor Audio PLW215II Guide De Configuration page 4

Amplifier
1
2
3
4
5
6
7
9
10
1. USB Connector
This is provided to update the firmware and settings of the PLW215 II in conjunction with the SubConnect application (refer
to the electronic manual).
2. RS-232 Input
For use with home automation systems and uses a conventional RJ45 connector, refer to the electronic manual for the wiring
configuration and set up protocol.
3. 12 Volt Trigger Input ~ Centre Pin = +12Vdc.
For external power control from AV amplifier/ receiver to the PLW215 II (lead supplied), and to toggle between different
presets depending on how it is set up in the SubConnect application (refer to the electronic manual). The default setting is
to control the power.
This 12 volt signal comes from the source amplifier and supplies the PLW215 II with a signal to perform a predetermined
action. This is either to turn it on or to switch presets. When used to turn the PLW215 II on and off, it is a very energy efficient
method of power control. The auto off timer and signal sense will not operate when the 12v trigger is connected.
2
8
PLW215 II
11
12
12a
13