Monitor Audio PLW215II Guide De Configuration page 6

Remote
1
2
3
4
5
6
7
8
4
1. Preset 1
Selects preset 1. The default EQ profile is Music mode.
2. Preset 2
Selects preset 2. The default EQ profile is Movie mode.
3. Preset 3
9
Selects preset 3. The default EQ profile is Flat mode.
4. Preset 4
10
Selects preset 4. The default EQ profile is Impact mode.
11
5. + Vol
Increases the volume trim level.
12
6. Enter
Selects/ confirms the command.
7. - Vol
13
Decreases the volume trim level.
14
8. LED Brightness
Toggles the LED display on or off.
9. Standby
Puts the PLW215 II into standby or wakes it up from
standby. Refer to page 6
10. Mute
Mutes all output from the PLW215 II.
11. Crossover Point
Selects the crossover control on the PLW215 II. Use the
left and right arrows to adjust the crossover frequency.
This is set in 5Hz steps from 20 to 135 Hz.
12. Phase
Selects the phase control of the PLW215 II. Use the left
and right arrows to adjust the phase. This is set in 15
degree increments from 0 - 360 degrees.
13. Left arrow
Adjusts the chosen control.
14. Right Arrow
Adjusts the chosen control.
PLW215 II