Operation; General - Hatco MDW Série Manuel D'installation

OPERATION

General

Use the following procedure to turn on and operate the Hatco
Mini Display Warmer.
WARNING
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
Startup
1. Plug unit into an electrical receptacle of the correct voltage,
size, and plug configuration. See the SPECIFICaTIONS
section for details.
2. Move the Power I/O (on/off) switch to the I (on) position.
3. Set the Temperature Control to the desired level between
MIN and MaX.
BURN HAzARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
4. allow 30 minutes to preheat. Check the interior
thermometer and adjust the Temperature Control if
necessary.
NOTE: Temperature settings may vary depending upon
product make-up and consistency. The interior
thermometer displays temperature inside the cabinet,
not the food product temperature.
Shutdown
1. Move the Power I/O (on/off) switch to the O (off) position.
2. Unplug the power cord and allow the unit to cool before
performing any cleaning or maintenance.
CAUTION
8
English
Interior
Thermometer
Power I/O Switch
Temperature
Control
Control Panel
Form No. MDWM-1214