Publicité
Les langues disponibles
Les langues disponibles
Using Vicks
VapoPads
®
Your Vicks Warm Mist Humidifier can be used with Vicks VapoPads
of soothing vapors. One free sample of the menthol VapoPad is included with your humidifier.
To use your unit with scent pads:
Step 1
Step 2
1.
Open Scent Pad Door.
2.
Open Scent Pad by tearing notch on pad bag. DO NOT touch pad with hands. If pad is touched,
DO NOT rub face or eyes as it may cause irritation.
3.
Insert Vicks Scent Pad with angled end facing towards the product. Up to two scent pads can
be inserted. Close door.
4.
After 8 hours, discard scent pad. To continue using scent pads, repeat steps 1-4.
VapoPads
Recommended Usage:
®
•
Not recommended for infants under 10 lbs (4.5 kg).
For children between 10-22 lbs (4.5-10 kg ), DO NOT use more than 2 pads in a 24 hr period.
•
Scent Pad Ingredients (VSP-19, VSP19FP, VSP19VPC, VSP-19 CAN): Eucalyptus Oil, Menthol,
Glycol,Cedar Leaf Oil, & Others.
Cleaning Your Humidifier
To keep your humidifier running efficiently, clean it regularly. Weekly cleaning is recommended. All
maintenance should be done in the kitchen or bathroom on a water-resistant surface near a faucet.
To properly clean your humidifier, we recommend the separate processes of Scale Removal
and Disinfecting. These two processes must be performed separately.
Before Cleaning:
Step 1
Step 2
1.
Turn off and unplug humidifier. NEVER clean the humidifier when it is running. If the
humidifier has recently been in use, wait at least 20-30 minutes for unit to cool
before beginning cleaning process.
2.
Remove any accessories, and empty medicine from Medicine Cup. Then remove and empty
Water Tank and set aside.
3.
Pull blue Locking Latch toward front of unit (a) and lift Mist Chimney up (b) to remove. Remove
Water Tray from Base by pulling up from the Tab (c) and the opening in front of the Latch, then
empty Water Tray.
4.
Replace Water Tray and Mist Chimney. These must be in place for cleaning. See
Reassembling section.
6
®
®
to provide up to 8 hours
Step 3
Step 4
Step 4
Step 3
B
A
C
Cleaning Your Humidifier
Scale Removal:
Keeping the Heating Element free of scale will help the humidifier to run efficiently.
Step 1
Step 2
Step 4
Step 5
1.
Remove Water Tank and slowly pour 2 cups (.5 liters) of undiluted, distilled white vinegar
into the Reservoir on the Water Tray. DO NOT pour vinegar over the blue Locking Latch.
Only pour into the deep Reservoir. Note: Pour slowly to give enough time for vinegar
to flow from the Reservoir into the Heating Chamber. The vinegar will slowly begin
to fill the Heating Chamber, located under the Mist Chimney. Let soak for 20 minutes to
loosen scale on the Heating Element.
Water Tank scale removal steps:
Pour additional vinegar into the Water Tank, replace Cover and swish to coat inside of Tank.
Use a cloth dampened with vinegar to wipe away any scale on the inside of the Tank and Cap.
2.
Remove the Mist Chimney by gently sliding blue Locking Latch towards the front of the
unit (a) and lifting Chimney upwards (b).
3.
Remove Heating Element Cover by lifting from the large round opening and pulling away
from the Chimney.
4.
Wet the bristles of a soft brush with vinegar from the Water Tray and gently scrub
the surface of the Heating Element, Heating Element Cover, Reservoir, and Heating
Chamber to remove mineral deposits.
DO NOT USE HARD BRUSHES, STEEL WOOL, OR OTHER HARD ABRASIVES ON THE
HEATING ELEMENT. DOING SO WILL DAMAGE THE HEATING ELEMENT.
DO NOT POUR VINEGAR DIRECTLY ONTO THE HEATING ELEMENT.
NOTE: If scale is still visible on the Heating Element, moisten a paper towel with vinegar, and
wrap it around the Heating Element. Let it sit for 30 minutes or until scale loosens.
IMPORTANT: Remove paper towel from the Heating Element before proceeding to the next step.
5.
Remove Water Tray by gently lifting from the Tab and the opening in front of the Latch, and
empty vinegar in sink. Rinse Water Tray and Heating Element Cover with water until the
smell of vinegar is gone.
6.
With a soft damp cloth, wipe Heating Element to remove any excess scale. Snap Heating
Element Cover back on the bottom of the Mist Chimney. It will only fit one way.
CAUTION: DO NOT RINSE HEATING ELEMENT OR MIST CHIMNEY IN SINK OR UNDER
RUNNING WATER AS WATER CAN GET INTO INTERNAL PARTS. DOING SO WILL DAMAGE
THE HUMIDIFIER AND VOID THE WARRANTY. ONLY USE A WET CLOTH OR PAPER TOWEL
TO CLEAN THIS PART.
(Continued)
Step 3
B
A
Step 6
7
Publicité
