Logitech Harmony Mode D'emploi page 39

Logitech Harmony remote control unit for Nikobus
In the example above, output 1 of the dimmer controller, in mode 1, is connected with position 9AB of the infrared receiver. Therefore, this output will work if you first
select channel 9 and then use the "action buttons" A and B.
important to note:
- You can work in two steps: first select the channel and then press A, B, C or D.
- Or you can program the combination in one button, e.g. 17C (selects channel 17 and then transmits code C).
o Attention: Buttons that contain a combination cannot send long commands.
o Therefore, these buttons cannot be used for the following:
• To dim (up or down)
• To activate atmospheres
• To activate functions with operating times
• To operate in push button mode
For these uses, always utilize 2 separate buttons.
nv Niko sa
Industriepark West 40, BE-9100 Sint-Niklaas, Belgium — tel. +32 3 778 90 00 — fax +32 3 777 71 20 — e-mail: support@Niko.be — www.niko.be
PHlogitechR10113