Peg-Perego Pliko mini Notice D'emploi page 13

parts missing or signs of breakage.
_ WARNING Never leave the child
unattended.
_ Always apply the brake when
stationary and when loading or
unloading children.
_ Do not insert fingers into the
mechanisms.
_ Be careful not to hurt the child
when adjusting the mechanisms
(handlebar, backrest ... ).
_ Any load applied to the handle and/
or the backrest and/or laterally to
the product can compromise the
stability of the product.
_ Do not load the baskets over 5
Kg. Do not put weight in the cup
holder (if present) in excess of
those indicated on the cup holders
themselves and never hot drinks. Do
not put loads of more than 0.2 Kg in
the hood pockets (if present).
_ Do not use the product near to
stairs or steps, heat sources, naked
flames or dangerous objects within
reach of the child.
_ Only replacement parts supplied or
recommended by the manufacturer/
distributor shall be used.
_ WARNING This product is not
suitable for running or skating.
_ WARNING Do not add any
mattress are not approved by the
manufacturer.
_ Do not use accessories which are
not approved by the manufacturer.
The images referring to the textile details may
differ from the collection purchased.
For more information, consult our website:
www.pegperego.com
INSTRUCTIONS
1 OPENING: to open the stroller, unhook the left hand
side lever (fig_a), hold the handles and at the same
time lift the stroller.
Check that the stroller has opened properly by
ensuring that the side hooks are well secured (fig_b).
2 If the hooks are not secured properly, press the seat
downwards (fig_c) until they click into place. Finally,
press downwards on PUSH with your foot (fig_d).
3 ASSEMBLING: to mount the front wheels, firstly check
that the washer is present, as shown in the figure, then
lower lever A and slip wheel B on until it clicks into place.
4 To mount the rear wheels connected by the brake cable,
place them with the brake facing externally (fig_a).
WARNING: ensure the hooks have clicked into place, as
in figure b.
5 Finally, hook the central element of the brake cable onto
the chassis, ensuring it clicks into place, as in the figure.
6 BASKET: to mount the basket, slip the loops over the
rear hooks 1 and 2 and the front hook 3 (fig_a).
ADJUSTING THE HANDLES: the height of the handles
can be adjusted. Press the little button behind the
handles and pull upwards. To lower the handles, do the
opposite (Fig. b).
7 SWIVEL WHEELS: In order to make the wheels swivel,
the lever (arrow 1) must be lowered. To secure the
wheels, move the lever to the opposite direction
(arrow 2). The rear wheels are fixed.
BRAKE: To set the brake on the stroller, lower the lever
on the rear wheel unit with your foot. To release the
brake, lift the lever (fig_b). When stationary, always
apply the brake.
8 HOOD: To fit the hood, click the fasteners onto the
appropriate points until you hear them click (fig_a).
Fasten the two side buttons as shown (fig_b - c).
Finally, button down the hood on the rear of the
stroller's backrest (fig_d).
9 The hood can be set to 2 positions, simply by pulling it
backwards or forwards.
10 5-POINT SAFETY HARNESS: to fasten, insert the two
buckles of the waist strap (with attached shoulder
straps, arrow a) into the leg divider strap until they
click into place (arrow b). To unfasten them, press the
button which is situated in the centre of the fastener
(arrow c) and pull the waist strap outwards (arrow d).
11 To tighten the waist strap, pull on both sides in the
direction of the arrow. To loosen it do the opposite.
12 It is possible to set the safety harness at 3 different
heights, depending on how tall the child is. As the
child gets bigger, the harness must be moved to a
higher position.
13 To adjust the height of the safety harnesses, release
the two buckles on the rear of the backrest.
Pull the shoulder straps towards you (arrow a) until the
buckles are released and insert them in the backrest
loops (arrow b). Remove the shoulder straps from the
sack (arrow c) and insert them in the most appropriate
buckle (arrow d), then reattach the two buckles
behind the backrest (arrow e). The buckles are securely
attached when a click is heard (fig f).
14 LEG REST ADJUSTMENT: The leg rest can be set in 2
different positions. To lower the leg rest, pull the two
side levers downwards and at the same time lower the
leg rest. To raise the leg rest, push it upwards until it
clicks into position (fig_a).
BACKREST ADJUSTMENT: to adjust the backrest, lift
the handle and recline it to the desired position. The
backrest can be adjusted into different positions (fig_b).
15 FOLDING UP: pull one lever followed by the second
lever upwards until you hear them click (fig_a); then,
hold the central handle (fig_b) and pull it upwards
until the stroller folds up.
When folded, the stroller will stand upright (fig_c).
16 CARRYING: The stroller can be conveniently carried
(with the front wheels set on stationary) by the central
handle (fig_a). It can also be carried by the side handle
(fig_b).
17 REMOVABLE LINING: to remove the lining from the
stroller, unhook the fasteners on the rear of the
backrest (fig_1), slip the fastener of the leg divider out
from under the seat (fig_2), loosen the two screws
(on both sides) using a screwdriver to keep the nut
fastened (fig_3),
18 unhook the elastic from the chassis (fig_4), unhook the
chassis (fig_5, see OPENING paragraph, point 1), slide
the sack off the chassis (fig_6),
19 slide the sack off the footboard (fig_7).
and pull the sack upwards (fig_8).
SERIAL NUMBERS
20 The Stroller PLIKO MINI has all the following
- 13 -