CD5000_ENG.book Page 75 Wednesday, December 7, 2005 6:22 PM
Other displays
Displaying a memo
If memos have been set, a memo recorded
corresponding to a number button [1] to [5]
appears on the screen when the number button
is pressed briefly while the power of the main unit
is turned off.
Setting a memo
Press and hold any number button
1
for more than two seconds while in
the Standby mode.
The state shifts to the MEMO setting
mode.
Press the [
] button to select the
2
character type.
Pressing the button will switch types
from [ABC] (alphabet characters) to
[123] (numeric characters) and then
[!&?] (symbols).
Press either [SEL] or [
3
select the position in which to
enter the character.
The character will be inserted where
the cursor is flashing:
[SEL] button:
Moves the cursor to the right.
[ ] button:
Advances the cursor to the left.
Pressing and holding the [ ] button
moves the cursor to the left.
Turn the [SEL] button to the left or
4
right to select characters.
Turn to the right:
Advances the character forward in
its type.
Turn to the left:
Moves the character backward in its
type.
[Upper-case alphabet characters] Initial
value [A]
[Numeric
[Right direction]
[Symbol] Initial value [!]
[Right direction]
Press the [SEL] button to select
5
characters.
ATTENTION
• To change the type of character to be
entered, repeat steps 2 and 3.
• A maximum of 10 characters may be
] button to
entered per memo.
• A maximum of 5 memos may be stored.
6
Press the [RTN] button.
Memo settings are now completed.
Deleting a memo
Press
1
corresponding to the memo to be
deleted for more than two seconds
while the power is turned off.
Press the [6] button for more than
2
two seconds.
The memo will be deleted.
Other displays
[Right direction]
A ➔ B ➔ C ➔
X ➔ Y ➔ Z ➔ A
characters]
Initial
1 ➔ 2 ➔ 3 ➔
8 ➔ 9 ➔ 0 ➔ 1
! ➔ " ➔ # ➔ $ ➔ % ➔ & ➔ ' ➔ ( ➔ )
➔ * ➔ + ➔ , ➔ - ➔ . ➔ / ➔ : ➔ ; ➔ <
➔ = ➔ > ➔ ? ➔ @ ➔ ´ ➔ _
➔ !
the
number
value
[1]
XIII
XIV
button
75