How To Change The Memory Stick; How To Resume Normal Operation (Esn Security Lock Out) - Eclipse CD5000 Manuel D'utilisation

CD5000_ENG.book Page 40 Wednesday, December 7, 2005 6:22 PM
Various Settings

How to change the Memory Stick

You can change the Memory Stick and
security code that have been recorded by the
main unit to a different Memory Stick and
security code.
Cancel the security code that has
1
been recorded with the main unit.
Refer to "How to cancel the Memory
Stick security" on page 38.
Re-record the new Memory Stick
2
and security code that you would
like to use.
Refer to "How to record a security
code" on page 38.
How to resume normal operation
(ESN security lock out)
If power is disconnected while ESN security is
active (a security code was recorded),
operation is disabled until power is restored
and the main unit unlocked. Follow this
procedure to resume normal operation.
ESN security lock can be canceled by directly
entering the security code into the main unit,
or by using the Memory Stick that was being
used when the security code was recorded.
Canceling ESN security lock out using
security code entry
When the power is turned on after
1
disconnecting the battery power, a
[SEC] message will appear for two
seconds. Thereafter, the message
changes to [- - - -] (Security code
input display).
40
A security code is entered by
2
pressing the buttons [1] to [4].
Enter a four-digit security code using
digits 0 to 9, A to F. The number
(shown on the display) changes in
ascending order between 0 and 9, A
and F each time the button is pressed.
Each button number
corresponds to each digit (first to
fourth) of the security code.
Press the [FUNC] button for more
3
than one second.
If the security code matches the code
recorded by the main unit, [OK] will
appear on the display and the security
function will be canceled.
ATTENTION
• If the security code does not match the
information recorded by the main unit,
[ERR_ ] (ERR and the error number) will
appear on the display for two seconds, and
then [- - - -] (security code entry display) will
appear. If this happens, check the security
code and repeat the procedure from step 2.
• If [ERR5] (the 5th time an error has
occurred) appears, [HELP] will appear.
When [HELP] appears,
operations for an ESN security lock out by
following the procedure in "What happens if
a Memory Stick or
incorrect?" on page 41.
(1 to 4)
carry out the
security code is