What Happens If A Memory Stick Or Security Code Is Incorrect - Eclipse CD5000 Manuel D'utilisation

CD5000_ENG.book Page 41 Wednesday, December 7, 2005 6:22 PM
Canceling ESN security lock using
Memory Stick
After the battery is connected and
1
the main unit's power is turned on,
[SEC] will appear on the display for
two seconds. After this, [- - - -]
(security code entry display) will
appear.
2
Press the [DISC MS] button.
[MS] will appear on the display. If you
press the [DISC MS] button once
more, the display will return to [----]
(security code entry display).
ATTENTION
If a Memory Stick has already been inserted, a
[MS EJECT] message appears. In this case,
eject the Memory Stick and insert again. (Refer
to "Ejecting the Memory Stick" on page 27 for
details on ejection of the Memory Stick.)
Insert the Memory Stick in which
3
data have been recorded, and then
close the front panel.
The recorded data will be read from
the Memory Stick.
If the contents recorded in the
4
Memory Stick
information recorded by the main
unit, [OK] will appear on the
display for two seconds, and then
the main unit will return to normal
operation.
• If the contents recorded in the Memory Stick
do not match the information recorded by
the main unit, [ERR_ ] (ERR and the error
number) will appear on the display for two
seconds, and then [- - - -] (security code
entry display) will appear. If this happens,
check the Memory Stick and repeat the
procedure from step 2.
• If [ERR5] (the 5th time an error has
occurred) appears, [HELP] will appear.
When [HELP]
operations for an ESN security lock out by
following the procedure in "What happens if
a
incorrect?" on page 41.
• ESN security lock cannot be canceled by
this
containing the security code was formatted.
What happens if a Memory Stick or
security code is incorrect?
1
match the
Your security code and Memory Stick
can easily be forgotten. Write the
security code and Memory Stick title in
a reminder note (See page 93).
ESN security operating procedure
ATTENTION
appears,
Memory Stick or security
procedure if the
After the 5th incorrect attempt, the
display reads [HELP]
seconds.
After the [HELP] message
displayed for five seconds, serial
number will appear.
You will only get 5 unsuccessful unlock
code entries. After the 5th attempt, you
will be asked to insert the DISC (Key
CD). At this point, please contact your
local Eclipse dealer for procedure on
unlocking the main unit.
carry out the
code is
Memory Stick
VIII
for five
was
41