Orbegozo CP 70095 Manuel D'instructions page 12

Masquer les pouces Voir aussi pour CP 70095:

Les langues disponibles

CP 70095

BLADE ASSEMBLY AND INSTALLATION

1. Mount the fan blades using the blade screws and washers provided. See Fig. 6. Make

sure all blade screws are securely fastened.

2. Fasten blade assembly to the motor using the motor screws provided. Make sure all

screws are tightly fastened. See Fig. 7.

ELECTRICAL CONNECTIONS

Connect the wires from the power supply and the bracket to the wiring terminals as

follows:

Brown L Motor: Cable

Cable black L: Light

Neutral N Blue: wire

Green / yellow: ground wire.

MAINTENANCE

HOW TO REPLACE A LIGHT BULB

1. Switch the device off (preferably, turn it off at the circuit breaker) and leave to cool.

(Take care: light bulbs can get very hot when in use.)

2. Remove the bulb by holding it firmly and turning it anti-clockwise.

3. Take a new bulb and put it carefully into its holder. Screw it in clockwise.

4. Put the power supply on again and switch on.

Important: The bulbs for this fan must be E 27 / 40 W maximum

CLEANING

Clean with a soft, dry cloth. Never use scouring pads, abrasive or chemical cleaners. Do

not

allow condensation to come in contact with the electrical components.

Disposal of old electrical appliances

The European directive 2002/96/EC on Waste Electrical and Electronic Equipment

(WEEE), requires that old household electrical appliances must not be disposed of

in the normal unsorted municipal waste stream. Old appliances must be collected

separately in order to optimize the recovery and recycling of the materials they

contain, and reduce the impact on human health and the environment. The crossed

out "wheeled bin" symbol on the product reminds you of your obligation, that

when you dispose of the appliance, it must be separately collected. Consumers should contact

their local authority or retailer for information concerning the correct disposal of their old

appliance.

DECLARATION OF CONFORMITY:

This device complies with the requirements of the Low Voltage Directive 2006/95/EC

and the requirements of the EMC directive 2004/108/EC.