Publicité
Les langues disponibles
Les langues disponibles
CP 70095
Other specific safeguards
1. The method of disconnection from the mains
supply must incorporate a switch or isolator
with a minimum contact separation of 3
mm.on all poles.
2. Make sure that when the fan is fitted in the
chosen position, there is no possibility of the
rotating blades coming into contact with any
object. Blades should be at least 2.30 m from
floor when fan is hung.
3. If you are installing more than one ceiling fan
make sure that you do not mix fan blade sets,
even though they are from the same ceiling
fan model.
4. Before beginning, disconnect power by
removing fuse or turning off circuit breaker.
5. Once fan installation is completed make sure
that all connections are secure to prevent fan
from falling.
6. Fan must be turned off and stopped before
reversing fan direction.
7. Check that the means of fitting the fan to the
ceiling is capable of supporting the weight of
the fan when in operation. (Minimum 50Kg.).
OPERATING INSTRUCTIONS
1. The fan is controlled by using the pull chain as follows: one pull – high speed; two
pulls – medium speed; three pulls -low speed; four pulls - "off".
2. If the speed controls are changed regularly, the changes should be done as follows:
Change the control to position "1" (low speed), then increase as required and stop at
position "5" (high speed).
3. "Forward" and "Reverse" switch. Ensure power supply is turned off before reversing
the fan.
10
Publicité
