Niko 350-20054 Mode D'emploi page 23

350-20054 / 350-20055
6. TECHNICAL DATA
Dimensions:
Power supply voltage:
Power consumption:
Relay contact channel 1 and 2:
Maximum load:
Maximum switching capacity:
Maximum inrush current:
Detection angle:
Mounting height:
Detection range:
Light sensitivity:
Hysteresis on light sensitivity:
Switch-off delay channel 1:
Switch-off delay channel 2:
Protection degree:
Protection class:
Ambient temperature:
Cable inlet:
Quality mark:
7. WARNINGS REGARDING INSTALLATION
• The installation should be carried out by a registered installer and in compliance with the statutory regulations.
• This user manual should be presented to the user. It should be included in the electrical installation file, and it should
be passed on to any new owners. Additional copies are available on the Niko website or via the Niko support service.
• During installation, the following should be taken into account (non-exhaustive list):
- the statutory laws, standards and regulations.
- the technology currently available at the time of installation.
- this user manual, which only states general regulations and should therefore be read within the scope of each specific
installation.
- the rules of proper workmanship.
This product complies with all of the relevant European guidelines and regulations. If applicable, you can find the EU declaration
of conformity regarding this product at www.niko.eu.
EN
59 x 127 mm (HxW)
230 Vac ± 10%
< 1 W (350-20054)
< 1.5 W (350-20055)
NO (max. 10 A), light- and motion-sensitive
incandescent lamps (2300 W)
230 V halogen lamps (2300 W)
all low-voltage halogen lamps (1200 VA)
fluorescent lamps (non-compensated) (1200 VA)
economy lamps (CFLi) (350 W)
ventilation motor (690 VA)
led lamps 230 V (350 W)
140 uF
80 A/20 ms
360°
2.5 – 3 m
circle, up to max. 20 m
10 – 1000 lux
+ 10%
1 – 30 min
channel 1 value + 25%
IP20
class II devices
-5 – 50°C
2 x 12 mm
CE marked in compliance with EN 60669-2-1
23