Operation, Precautions - Atlas Copco BBD 46WS-6 Prescriptions De Sécurité Et Instructions Pour L'opérateur

BBD 46WS-6, 46WS-8, 46WR-6, 46WR-8
Never start the machine while changing the
►
insertion tool.
► Before changing the insertion tool or accessories,
stop the machine, switch off the power supply and
bleed the machine by activating the start and stop
device.
► Never point the inserted tool at yourself or anyone
else.
Make sure that the insertion tool is fully inserted
►
and the tool retainer is in a locked position before
the machine is started.
Check the locking function by pulling the inserted
►
tool outwards forcefully.
WARNING Moving or slipping insertion tool
An incorrect dimension of the inserted tool's shank
can result in that the inserted tool is lost or is slipping
out during operation. Risk of severe injury or crushed
hands and fingers.
Check that the insertion tool has the shank length
►
and dimensions that the machine is intended for.
Never use an insertion tool without a collar.
►

Operation, precautions

DANGER Explosion hazard
If a warm insertion tool comes into contact with
explosives, an explosion could occur. During
operation with certain materials as well as use of
certain materials in machine parts, sparks and
ignition can occur. Explosions will lead to severe
injuries or death.
Never operate the machine in any explosive
►
environment.
► Never use the machine near flammable materials,
fumes or dust.
► Make sure that there are no undetected sources
of gas or explosives.
Never drill in an old hole.
►
WARNING Unexpected movements
The inserted tool is exposed to heavy strains when
the machine is used. The inserted tool may break
due to fatigue after a certain amount of use. If the
inserted tool breaks or gets stuck, there may be
sudden and unexpected movement that can cause
injuries. Furthermore, losing your balance or slipping
may cause injury.
© 2010 Atlas Copco Construction Tools AB | No. 9800 0669 71 | 2010-03-19
Original instructions
Safety and operating instructions
Make sure that you always keep a stable position
►
with your feet as far apart as your shoulder width,
and keeping a balanced body weight.
► Always inspect the equipment prior to use. Never
use the equipment if you suspect that it is
damaged.
► Make sure that the handles are clean and free of
grease and oil.
Keep your feet away from the inserted tool.
►
► Stand firmly and always hold on to the machine
with both hands.
► Never drill in an old hole.
Never start the machine when it is lying on the
►
ground.
► Never 'ride' on the machine with one leg over the
handle.
► Never strike or abuse the equipment.
Check regularly for wear on the insertion tool, and
►
check whether there are any signs of damage or
visible cracks.
► Pay attention an look at what you are doing.
WARNING Stalling hazard
If the insertion tool gets caught during operation, the
whole machine will start to rotate if you lose your grip
on it. This unexpected rotation of the entire machine
may cause serious injury or death.
Stand firmly and always hold onto the machine
►
with both hands.
Make sure that the handle or handles are clean
►
and free from grease and oil.
► Never drill in an old hole.
WARNING Trapping hazard
There is risk of neck ware, hair, gloves and clothes
getting dragged into or caught by a rotating insertion
tool or accessories. This may cause choking,
scalping, lacerations or death. To reduce the risk:
Never grab or touch a rotating drill steel.
►
► Avoid wearing clothing, neck ware or gloves that
may get caught.
Cover long hair with a hair net.
►
9