Tristar PURESTAR Manuel De L'utilisateur page 9

ACTIVESTAR™ CELL & AIR FILTER CLEANING & REPLACEMENT
WARNING:
• Turn off the power switch in the rear of the unit.
• Unplug the unit and let it cool completely.
• Air filter requires cleaning after every 3-6 months of use, and
replacement as needed. Please remove the old filter and replace with a
new filter following the steps below.
• ActiveStar™ requires cleaning on a monthly basis and requires
replacement after every 2 years (based on normal heating season use).
1. Remove the screw from the back cover of the ActiveStar™ assembly.
Remove the screw and depress the two latches beneath the filter
housing, then lift up to remove.
2. Disconnect the ActiveStar™ cell plug.
3. To remove the ActiveStar™ assembly from the housing.
Spread the 4 retaining tabs that hold the ActiveStar Cell in place and
slide the Cell out of the housing. (A)
4. To remove the filter from the housing, spread
2 retaining tabs that hold the filter in place (B),
then slide the filter out of the housing (C).
5. The ActiveStar™ cell and filter can now be
replaced or cleaned. To clean, carefully vacuum
or brush the ActiveStar™ cell and filter. If
damaged, worn, or difficult to clean, replace the
filter and/or ActiveStar™ cell.
6. Reassemble the ActiveStar™ cell, filter, back
cover, and holder assembly as shown.
7. Insert the ActiveStar™ cell plug into the receptacle in the
back of the unit.
8. Replace the back cover screw removed in step 1.
9. Reconnect power.
WARNING! - The filter and ActiveStar™ Cell must
be properly installed. DO NOT OPERATE THIS
APPLIANCE WITH THE FILTER OR BACK COVER
REMOVED. Failure to follow these instructions may
result in exposure to UV light or personal injury.
ActiveStar
Cell
4 Tabs that hold the ActiveStar Cell in place (A)
Depress latches
2 Tabs that hold
the filter in place (B)
Filter Removal (C)
Housing
9