Setting The Timer - Tristar PURESTAR Manuel De L'utilisateur

Système de chauffage portatif avec technologie activestar
Masquer les pouces Voir aussi pour PURESTAR:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SETTING THE TIMER

00
UNIT CLEANING
WARNING:
• Turn off the power switch in the rear of the unit.
• Unplug the unit and let it cool completely.
• To keep the heater clean, the outer shell may be cleaned with a soft cloth.
CAUTION: DO NOT let liquid enter the heater.
• DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause
damage or deterioration to the surface of the heater.
• DO NOT immerse the heater in water.
• If unit should become wet, wait until unit is completely dry before using.
REMOTE CONTROL CARE
When remote control will not be in use for a long period of time, remove the battery according to the following steps.
8
Press Timer button either on the control panel
or remote control.
To set the Heater to automatically turn off, press
the Timer button with the unit ON. To set the
Heater to automatically turn on, press the Timer
button with the unit OFF.
until the LED on the control panel displays
the desired length of time. Time can be set in
1–12 hour increments. The Timer will begin
immediately.
DO NOT put liquids inside the heater.
Press continuously
Push battery cover lock
up then pull cover out as
indicated in the diagram
above. When replacing
+
the battery, positive side
faces up.

Publicité

Table des Matières
loading

Table des Matières