Remote Panel; Preparation - Tristar PURESTAR Manuel De L'utilisateur

REMOTE PANEL

PREPARATION

Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. Turn on the power switch
in the rear of the unit. Only operate heater in an upright position with caster wheels attached.
When using remote control, please pull out the insulating film as illustrated below.
6
Power button – for power on or off
Economy Mode Settings – Control the power output according to the room size to
conserve energy.
• Low – covers up to 300 sq ft
• Medium – covers 300-600 sq ft
• High – covers 600-1000 sq ft
Timer Button – Press the Timer Button when the heater is on to set the hours until the
unit turns off. Or press the Timer Button when the heater is off to set a time for the
unit to turn on automatically.
Fan Control Button – Switch the fan speed between Normal and High.
Temperature Control – Use the up button to set a warmer temperature and the down
button to lower the heat.