Step 10A Install Overlay Panels - Monogram ZIC360NNRH Instructions D'installation

Installation Instructions - Standard Installation

STEP 10A INSTALL OVERLAY PANELS

Use front holes to secure optional
ZKLN kit handle (not shown)
Use rear holes
to secure trim
Install door and drawer panels:
• Open door to 90°.
• Remove 4 screws holding trim, lift off trim.
Retain screws.
• Slide overlay panel into the door trim.
Custom handles
If you are using custom handles, the handle must be
properly secured to the panel before sliding the panel
into the trim.
• The cabinet manufacturer will supply the custom
handle and hardware.
• Secure the door/drawer trim using both the FRONT
and REAR screw holes.
Right hand models shown. Use the same
instructions for left hand models.
Door Trim
Refrigerator Door
• There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original
screws in the REAR screw holes.
• Follow the same procedures to install the drawer
panel.
20
31-1000452 Rev. 1