Publicité
Les langues disponibles
Les langues disponibles
•
Disconnect the charger from the outlet before
attempting any cleaning. This will reduce the risk of
electric shock. Removing the battery pack will not
reduce this risk.
•
Never attempt to connect 2 chargers together.
•
The charger is designed to operate on standard
household electrical power. Do not attempt to use it
on any other voltage. This does not apply to the
vehicular charger.
Save these instructions
Chargers
The SC201/ SC202 accept 18V batteries.
These chargers require no adjustment and are designed to
be as easy as possible to operate.
Charging Procedure (fig. 2)
1. Plug the charger (j) into an appropriate outlet before
inserting battery pack.
2. Insert the battery pack (g) into the charger. The red
(charging) light will blink continuously indicating that the
charging process has started.
3. The completion of charge will be indicated by the red
light remaining ON continuously. The pack is fully
charged and may be used at this time or left in the
charger.
Note: To ensure maximum performance and life of Li-Ion
batteries, charge the battery pack fully before first use.
Charging Process
Refer the tables below for the state of charge of the battery
pack.
State of charge–SC201
charging –– –– –– –– ––
fully charged ––––––––––––––––––––
hot/cold pack delay –– –– –– –––––––
Hot/Cold pack delay
SC201/ SC202
(Original instructions)
When the charger detects a battery that is hot, it
automatically delays charging until the battery has cooled.
When the charger detects a battery that is cold, it
automatically delays charging until the battery has warmed.
The red light will continue to blink, but a yellow indicator light
will be illuminated during this operation. Once the battery
has cooled, the yellow light will turn off and the charger will
resume the charging procedure.
Stanley Li-Ion tools are designed with an Electronic
Protection System that will protect the battery against
overloading, overheating or deep discharge.
The tool will automatically turn off if the Electronic Protection
System engages. If this occurs, place the Li-Ion battery on
the charger until it is fully charged.
Li-Ion battery packs only
Li-Ion batteries are designed with an Electronic Protection
System that will protect the battery against overloading,
overheating or deep discharge.
The tool will automatically turn off if the Electronic Protection
System engages. If this occurs, place the Li-Ion battery on
the charger until it is fully charged.
Important safety instructions for all battery
packs
When ordering replacement battery packs, be sure to
include catalog number and voltage.
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the safety
instructions below. Then follow charging procedures
outlined.
Read all instructions
•
Do not charge or use battery in explosive atmospheres,
such as in the presence of flammable liquids, gases or
dust. Inserting or removing the battery from the charger
may ignite the dust or fumes.
•
Never force battery pack into charger. Do not modify
battery pack in any way to fit into a non-compatible
charger as battery pack may rupture causing serious
personal injury.
•
Charge the battery packs only in STANLEY chargers.
•
DO NOT splash or immerse in water or other liquids.
ENGLISH
7
Publicité
