Publicité
Les langues disponibles
Les langues disponibles
2. INSTALLATION
Attention
• These instructions are mandatory for the home motorisation and automation professional
installing the drive.
• Never drop, knock or puncture the drive or immerse it in liquid.
• Install an individual control point for each drive.
Make sure that LED, programming button and input connection remain visible and easily accessible
after installation.
2.1. ASSEMBLY
2.1.1. Drive preparation
Attention
• Sonesse 28 WireFree RTS: interior diameter of the tube has to be Ø26.6 mm or greater.
• Sonesse ULTRA 30 WireFree RTS: interior diameter of the tube has to be Ø27.7 mm or
greater.
2.1.2. Tube preparation
2.1.3. Drive/tube assembly
2.1.4. Mounting the tube-drive assembly on the brackets
For optimal radio reception, the motor antenna should be kept
straight and should be positioned outside of headrail (if used).
2.2. WIRING
Precaution
• To ensure electrical safety, this Class III motor must be powered by a «SELV» voltage source
(Safety Extra Low Voltage).
• The battery level must be below 30% before shipping by air.
Attention
• Use power charger (recommended by Somfy) to charge the drive battery.
• Ensure battery is fully charged prior to installation on site.
• Before setting, it is necessary to charge the battery only if the LED blinks red 5 times when
you press any button on the paired control point.
The drive will go back to sleep if le untouched
for 15 minutes.
1
2
1
1
2
a
LED illuminates
Behaviour
EN
a b
2
b
Publicité
