Installation - Blumfeldt Dark Wave Mode D'emploi

INSTALLATION

Wall mounting
1 There are 4 brackets and fasteners used with the heater. Furthermore, in
the canal of back side of the heater there are 4 square fastener washers
25×25mm. Take the square washers (Figure 1)and fasten 2 brackets to the
canal of the backside of the heater by the help of screws (Figure 2) .
2 Fasten the brackets at the appropriate distance of each other (45-55cm)
(Figure 3).
3 Two other brackets are fastened by the help of fasteners at the
appropriate distance on the wall parallel to the floor (At least 1.8 m from
the floor and at least 0.5 m from the ceiling). (Figure 4).
EN
17