Publicité
14/14
Bosch Rexroth AG Hydraulics
Unit dimensions (dimensions in mm)
Project planning / maintenance instructions / additional information
– The amplifier card may only be unplugged and plugged when de-energized.
– The distance to aerial lines, radios and radar systems must be sufficient (> 1 m).
– Do not lay solenoid and signal lines near power cables.
– For signal lines and solenoid conductors, we recommend using shielded cables.
The cable shield must be connected to the control cabinet extensively and as short as possible.
– The valve solenoid must not be connected to free-wheeling diodes or other protective circuits.
– The cable lengths and cross-sections specified on page 5 must be complied with.
Bosch Rexroth AG
Hydraulics
Zum Eisengießer 1
97816 Lohr am Main, Germany
Phone +49 (0) 93 52 / 18-0
documentation@boschrexroth.de
www.boschrexroth.de
VT-VARAP1-...-2X/... RE 30058/06.12
Plug-in connector
DIN 41612 - F 32
160
© This document, as well as the data, specifications and other informa-
tion set forth in it, are the exclusive property of Bosch Rexroth AG. It
may not be reproduced or given to third parties without its consent.
The data specified above only serve to describe the product. No state-
ments concerning a certain condition or suitability for a certain applica-
tion can be derived from our information. The information given does not
release the user from the obligation of own judgment and verification. It
must be remembered that our products are subject to a natural process
of wear and aging.
Publicité
Chapitres
