Publicité
Les langues disponibles
Les langues disponibles
USING:
4- To fix seat to the table, push it right to the bottom edge of the table; make sure that
clamps are well against the table edge (Fig. 4). Fix clamps turning them until they well
locked to table's surface (Fig. 5) tighten them strongly.
WARNING: Check that the seat is firmly fixed to the table and that the table attached to it,
will not tip pushing down and pulling it slightly (Fig. 6).
5- After making sure that table-chair is firmly fixed to the table, let sit your baby and fasten
seat belts to the buckle (Fig. 7). Cover the buckle with the flap closing buttons (Fig. 8).
6- Adjust well the width of the belts (Fig. 9).
CHECKING TABLES PROFILES:
Not all tables have the same characteristics, shapes and sizes, beware of the profile of the
table top where you assembled the table-chair. We recommend you to NOT assemble
table-chair on tables with beveled or very rounded, with corners OVER 35 mm (Fig. 10). On
these types of tables, even if clamps are properly fixed against the edge (as in Fig. 4), there
is a risk that table-chair may slip and break away from the table with the consequent
dangers and injuries to your child.
WARNING: DO NOT fix table-chair on tables with special profiles/top such as they can not
provide and ensure a secure fastening of clamps to the table (Fig. 11). There is a DANGER
OF DETACHMENT AND FALL of table-chair with the consequent dangers and injuries to
your child.
If in doubt, do not use table-chair.
HOW TO REMOVE THE SEAT:
WARNING: Before take the child out from the seat, take care that his legs are not trapped
into clamps or into other parts of the table-chair.
7- After unfastened seat belts, take your child out and loosen the clamps. Pull out table-
chair from the table, close clamps by turning inward.
8- "GURME" is equipped with a carrying bag stowed in a compartment under the seat (Fig.
12). You can storing table-chair in when transporting it, closing bag with the appropriate
drawstring (Fig. 13).
11
Publicité
