Publicité
Les langues disponibles
Les langues disponibles
SECURE AN ITEM FOR CUTTING
A. Raise the band saw head.
B. Locate the vise screw handle (K, fig 2, 3 & 4).
C. Rotate the vise handle counter-clockwise until there is enough room for
your work piece between the vise plates (J, fig 2, 3 & 4).
D. Place the work piece between both of the vise plates.
E. Rotate the vise handle clockwise until the sliding vise plate clamps the
work piece against the mitering vise plate.
F. For making repeat cuts of the same length, install, set to length and use
the workpiece stop.
OPERATING
INSTRUCTIONS
WARNING! Before using this machine, operators should carefully
read over this operation manual and acquaint themselves with the
construction, controls and drive system of the saw.
WARNING! Always disconnect the tool from power source before
making any adjustments, storing, servicing, or changing accessories.
Such preventative safety measures reduce the risk of starting the tool
accidentally.
WARNING! The machine is fitted with a mains switch (I, fig 2 & 3)
To be activated before any work is performed. Once work has been
completed, turn off the mains switch (O, fig 2, 3 & 4).
WARNING! Never wear gloves when using this machine.
● Before commencing a new job, always remove the cuttings left from the
previous task.
● Keep hands well away from the cutting zone.
WARNING! Running-in the blade: perform a correct running-in
procedure as indicated in the heading "Blade Replacement".
USING THE BANDSAW
1. Secure the workpiece to be cut in the clamp using the vise screw handle
(K, fig 2, 3 & 4).
2. Turn on the mains power (shown at I, fig 2, 3 & 4)
3. Press start button (C, fig 2, 3 & 4) to commence work.
4. Lower the head slowly until the blade comes into contact with the
workpiece.
CAUTION: To avoid breaking the blade, reduce pressure as soon as
the blade comes into contact with the workpiece.
5. Complete cutting up to the end of the stroke.
6. Release the start button to stop work.
7. Lift the head as far as it will go.
8. Turn off the mains power by pressing the power off switch
(O, fig 2, 3 & 4).
CAUTION: Let the cut piece fall onto the base of the machine. NEVER
bring hands anywhere near the cutting zone until the head has returned
to its full height and the blade has come to a complete standstill.
14
Publicité
