Publicité
Les langues disponibles
Les langues disponibles
2. Place the threaded end of the rod through the stop assembly mounting
hole (AA, fig 1 & 2)
3. Re-attach the nut from the inside of the base and tighten.
POSITIONING / WORK STATION
Position the machine on a work bench or pedestal with a height of between
35-1/2 and 37-1/2 inches (900 to 950 mm) above the floor. The surface on
which the machine is placed must be big enough to guarantee machine
stability.
WARNING! This machine should be positioned in the work area
ensuring a horizontal clearance of at least 31.5 inches (800 mm) from all
sides of the machine.
Secure the machine to the workbench with M8 screws through the two
holes provided in the base.
ELECTRICAL CONNECTION
Ensure that safety standards for electrical connections detailed in the
section Electrical Warnings and Cautions, above, are followed.
WARNING! Check that the power supply system is equipped with a
thermomagnetic circuit breaker to protect all conductors from short circuit
and overloads.
CHECKS AFTER CONNECTION
WARNING! Before connecting it to mains power, check that the supply
voltage matches the voltage indicated on the machine itself.
Once connected, to avoid any possible residual risks of tripping and falling,
make sure that the power supply cable lies flat on the floor and is not at
any point raised in the air.
ELECTRICAL SYSTEM
NOTE: The bandsaw's electrical system is fitted with an under-voltage
relay.
● This automatically opens the circuit if the voltage drops below a
minimum set limit and prevents automatic restart when the voltage
returns.
● Should this happen, the machine must be switched off before it will re-
start.
ADJUSTMENTS
WARNING! Perform all the procedures for machine adjustments and
use described in the following headings only after this instruction, use
and maintenance manual has been read and understood in full.
CAUTION:
„ At the end of every adjustment operation, check that all fasteners are
secure.
„ At the end of every adjustment operation make sure no tools have
been left on the machine.
ADJUSTING BLADE TENSION
Turn the blade tensioning handwheel (B, fig 2, 3 & 4) clockwise up to the
travel stop.
CAUTION: If the band tension is too high the blade may jump out of
the guides.
ADJUSTING CUTTING ANGLE
HEAD ROTATION
The machine comes with basic calibration set at 0° and 45°, by mechanical
stoppers: the 0º miter limiter and 45º miter limiter (P & Q, fig 2 & 3).
WARNING! To check or modify calibrations, please contact an
authorized after sales service center.
12
Publicité
