Skil TS6307-00 Guide D'utilisation page 21

3. Lower the front of the main barrier guard until the mounting fork is parallel to the table
(Fig. 13).
4. Press down on the guard-release lever until you feel and hear it snap into the locking
position. Check that the main barrier guard is securely connected (Fig. 13).
Fig. 13
Attaching the anti-kickback device
WARNING
damaged anti-kickback pawls . Dull or damaged pawls may not stop a kickback
increasing the risk of serious personal injury .
1. Press and hold the anti-kickback device lever. Align the slot in the pawls over the rear
notch on top of the riving knife (Fig. 14).
2. Release the anti-kickback device lever to snap it into place. Check that the anti-kickback
device is securely connected. Carefully raise and lower the pawls – when letting go, the
spring-loaded pawls must come down and contact the table insert (Fig. 15).
NOTE: The main barrier guard and anti-kickback device are independent of each other, so the
anti-kickback device can be attached before the main barrier guard.
Fig. 14
Guard Release Lever
Always install the anti-kickback pawls onto the riving knife with the
guard when performing "through cutting" operations . Replace dull or
Lever
1
2
Fig. 15
Pawls
21