Skil TS6307-00 Guide D'utilisation page 30

Fig. 32
Fence
Adjusting riving knife (horizontally and
vertically)
Check that the blade is properly aligned paral-
lel with the miter-gauge slot per instructions in
"Adjusting Blade Parallel to The Miter Gauge
slots" and adjust the blade if necessary. Check
that the rip fence is aligned with the blade (see
instructions in "Aligning Rip Fence") and adjust
the rip fence if necessary.
1. Raise the saw blade to its full height.
2. Remove the barrier-guard device and the
anti-kickback device from the riving knife.
3. Remove the table insert.
4. From the left of the saw, use a 5mm hex
wrench (not included) to loosen the clamp
screws (1/4-1/2 turns) that hold the mounting bracket (Fig.34).
5. Reposition the riving knife left or right as needed to align the riving knife with the saw
blade.
6. Once properly aligned, securely retighten the clamp screws.
7. Check again for
30
Riving Knife
perpendicularity and continue to adjust as needed.
Fig. 33
Three Thicknesses of
Paper
Fence
Fig. 34
Clamp Screw
Wrench
Riving
Knife
Mounting Bracket