Terminology And Symbols Used In This Manual - Aprimatic G-MATIC AP350 Notice D'installation Mécanique, D'utilisation Et D'entretien

1

TERMINOLOGY AND SYMBOLS USED IN THIS MANUAL

•
INSTALLATION AREA: the area required to perform installation in which the presence of persons is hazardous for
the persons themselves (Appendix I, 1.1.1 Directive 98/37/EEC);
•
EXPOSED PERSON any person located in full or in part in a hazardous area (Appendix I, 1.1.1 - Directive
98/37/EEC);
•
INSTALLER person responsible for installation, operation, adjustment, maintenance, cleaning, repair and
transporting of the device (Appendix I, 1.1.1 - Directive 98/37/EEC);
•
RESIDUAL HAZARD risks which cannot be eliminated or suffi ciently reduced as part of the design process
lead to death and serious injury and which could create a long-term health and environmental hazard.
cause serious damage to the machine or to the product.
CE CONFORMITY DECLARATION
(machinery Directive 98/37/CE, Attached II, part B)
declares that the product:
AP350
Is suitable with requirement of the Directive 89/392/CEE and next modifications
Is suitable with following requirement of other Directives CE
89/336/CEE (electromagnetic compatibility) and next modifications
73/23/CEE (low tension) and next modifications
declare moreover that they have been applied the following harmonized norms:
EN 292 1/2 - Emergency of the machinery -general principles of planning
EN 60335-1 - Emergency of the apparatuses electrical workers of domestic use – general norms
EN55014-1 - Conduct Emissions - irradiated power
DS41035-002
This symbol is used to mark information, instructions and procedures which if ignored could
This symbol is used to mark information, instructions and procedures which if ignored can
The symbol is used to mark important information which if ignored could void your warranty.
10
LBT0218