LS2 AIRFLOW OF562 Mode D'emploi page 4

SAFETY
RECOMMENDATIONS
1. NO HELMET CAN PROTECT YOU AGAINST ALL
POSSIBLE IMPACTS AT LOW AND HIGH SPEED
In any case, in order to have maximum protection for your head, the helmet
must fit perfectly and the locking system must be knotted securely under
your chin.
The helmet should allow you to have peripheral vision while you are wearing
it. If your helmet is too big, it can move on your head when you are driving
your motorcycle which can cause it to fall off in case of accident or even block
your vision while driving.
In the first case, your helmet would not protect your head in case of accident
and this may result in a severe injury or even death.
In the second case, if your vision is impaired, this can cause an accident.
2. ONLY USE A HELMET THAT COMPLETELY HOLDS
YOUR ENTIRE HEAD AND TIGHTEN THE LOCKING
SYSTEM SECURELY UNDER YOUR CHIN
Open the helmet with your hands and put it on your head. Please check to
see if the helmet fits correctly according to the list of points to be checked.
Pull the straps of the locking system, not the mechanisms. Pulling the mecha-
nisms could break them.
If you do not feel the helmet fitting snug, it is probably too big for you. In
order to knot a ring locking system, you need to take the end of the strap and
pull it through both rings and stretch the strap against your neck.
If the strap of the locking system is too loose, in case of impact, your helmet
could fall off your head, leaving it unprotected, resulting in a very severe
injury or even death.
3. HELMETS ARE DESIGNED TO ABSORB
ONE IMPACT ONLY
After your helmet has protected you from an impact you must replace it with
a new one.
Your helmet has been designed to distribute the energy of the impact over a
large area. Even if your helmet looks like it is not visibly affected, its usable
life ended after the impact.
For instance: an accident where you and your helmet fall down on the ground
or you crash against any object. In the event of collision, the inside of the
helmet absorbs the impact and this remains compacted. Once this happens,
your helmet no longer has the capacity to absorb impacts.
Your helmet may look perfect but it will no longer offer you the same pro-
tection in case of accident. When in doubt, for instance, if the helmet drops
or crashes against any object and you are no longer sure whether the rule
of the one impact may apply in this case, please contact your LS2 supplier
before using it again.
4. CLEAN YOUR HELMET CAREFULLY
Never use hot or salty water, gasoline, glass cleaners or any other solvent.
Your helmet could suffer severe damage due to these substances although no
visible damage is appreciated externally. A helmet deteriorated or weakened
by a cleaning agent may not offer protection in case of accident, causing
severe injuries or death.
The correct form of cleaning a helmet is mixing five or six drops of neutral
soap with half a litre of warm water. Introduce a soft cloth in the soapy solu-
tion and clean the helmet with the damp cloth.
EN
ES
FR
IT
DE
7