Cleaning The Appliance; Odors; Warning Messages Via The Display; Temperature Alarm - Siemens S18ID Série Notice D'utilisation Et De Maintenance

Cleaning the
appliance
m
WARNING
To avoid electrical shock which
can cause death or severe
personal injury, disconnect power
to appliance before cleaning.
After cleaning, reconnect power.
m
WARNING
To avoid personal injuries or
property damage, observe the
following:
– Do not clean the appliance with
a steam cleaner.
– Do not let the water used for
cleaning drip onto the tight or
contro) panel.
– Do not use abrasive or acidic
cleaning agents or solvents
which may damage the
surfaces of the appliance.
– Never clean shelves and
containers in the dishwasher.
The parts may warp.
Switch off the appliance with
the power button!
Pull out the mains plug or
switch off the fuse.
Clean the door seal with water
only and dry thoroughly.
Clean the appliance with
lukewarm water and a little
dishwashing liquid.
Do not let the water used for
cleaning drip onto the control
panel or light.
Check the ventilation openings
on the base panel. Remove dirt
with a vacuum cleaner.
Wash the shelves and
containers in lukewarm soapy
water and then rinse with clear
water.
Carefully remove persistent dirt
with a soft plastic brush.
To prevent stains, dry shelves
and containers with a soft cloth
immediately after cleaning.
Check the ventilation openings
on the panel.
After cleaning:
m
Reinsert the mains plug or
switch on the fuse. Switch on
the appliance with the power
button.
Have your supplier inform you
about special cleaning and care
information for appliance
surfaces.
m
Wipe appliance surfaces with
a damp cloth. Then immediately
wipe dry.

Odors

If the appliance is emitting
unpleasant odors:
Switch off the appliance with
the power button!
Pull out the mains plug or
switch off the fuse.
Take all food out of the
appliance.
Clean the interior.
See section on „Cleaning the
appliance".
Thoroughly clean all packing
containers used in the
appliance.
Pack strong-smelling food in
airtight containers to prevent the
build up of odors.
Switch on the appliance again
with the power button.
Stack food in the appliance.
After 24 hours check whether
the odors have been eliminated.
Warning
messages
via the display
If several warning messages are
displayed simultaneously, deal with
each message individually.
While a warning message is
displayed, buttons cannot be
pressed.

Temperature alarm

A temperature alarm is indicated by
the required temperature flashing
and the ALARM symbol coming on.
A signal also sounds if the Tone
function has been activated in Setup
mode.
Cause
– Power failure
– Large quantities of fresh produce
placed in the appliance
– Fault with the appliance
Remedial action
Press the alarm off button.
The signal stops. The highest
temperature in the appliance is
displayed for several seconds.
Determine the cause of the
temperature alarm.
When the required temperature
is reached again, the ALARM
symbol goes out and the signal
stops.
17