Disinfecting Surfaces; Cleaning Surfaces; Transport And Storage Conditions; Troubleshooting - Artyst NR.1 Manuel D'utilisation

The surfaces of the device are resistant
to:
Weak acids (e.g. boric acid ≤ 10%,
O
acetic acid ≤ 10%, citric acid ≤ 10%)
Aliphatic fluorocarbons (e.g. pentane,
O
hexane)
Ethanol
O
Most inorganic salts and their aqueous
O
solutions (e.g. sodium chloride, cal-
cium chloride, magnesium sulfate)
The surfaces of the device are not resis-
tant to:
Strong acids (e.g. hydrochloric acid
O
≥ 20%, sulfuric acid ≥ 50%, nitric acid
≥ 15%)
Oxidizing acids (e.g. peracetic acid)
O
Lyes (e.g. caustic soda, ammonia and
O
all substances with a pH value > 7)
Aromatic/halogenized
O
(e.g. phenol, chloroform)
Acetone and gasoline
O
7.3

Disinfecting surfaces

Disinfect the control unit, metal plate,
E
power supply and handpiece cable as
described in chapter 5.5 on page 35.
artyst NO.1
7.4

Cleaning surfaces

In the event of external contamination:
Wipe the device and its accessories
E
with a soft cloth moistened with a
cleanser or disinfectant.
8 Transport and storage condi-
tions
Device damage caused by dropping it
If the device is dropped, it can be damaged.
If the device falls, perform a visual in-
E
spection of the components.
Hand over the device to a specialist re-
E
tailer for inspection if it exhibits any ex-
ternal signs of damage or if it does not
function normally.
fluorocarbons
Always transport the device and its
E
accessories in the original packaging.
Fasten the metal plate of the device
E
for transport on the rear side.
Always store the device and acces-
E
sories under the following conditions:
NOTICE
-10°C to +40°C
Ambient tem-
perature
+14°F to +104°F
Relative hu-
10% to 90%
midity
Air pressure 540hPa to 1070hPa
9

Troubleshooting

9.1 Remedying problems when
operating the handpiece
If a longer signal tone sounds when the
handpiece is started and the message
CONNECT HANDPIECE or SYSTEM OVER-
LOAD appears on the display:
Ensure that a handpiece is connected
E
to the device (see chapter 5.4 on
page 35).
Ensure that you only use artyst hand-
E
pieces. Otherwise, the device can be
overloaded.
EN 39