Troubleshooting; Thermal Cut-Out - Hillyard Trident BU1500 Manuel D'utilisation Et D'entretien

THERMAL CUT-OUT

The machine is equipped with the following electrical protection systems, thermal cut-out (1), located
off the handlebars, to protect the motor. In the event of malfunctioning, check a thermal cut-out has not
intervened. If the motor overheats, its thermal cut-out intervenes to block the electricity supply. Wait a few
minutes until it has cooled down, then press the specific trip unit button to reactivate the power supply
and motor operation.
THE MACHINE VIBRATES OR OSCILLATES
In case the machine vibrates or oscillates during its operation, or has been sitting in rest position for too
long, with the pad still inserted, replace it as soon as possible.
MOTOR BRUSH WEAR INDICATOR
The machine is provided with a red warning light which indicates the base motor brushes are worn out.
When it is on contact a COMAC technician as soon as possible to replace the brushes.

TROUBLESHOOTING

15
15 15