E-MOOTIKA EMO000101NOC Manuel D'instructions page 82

E-MOTIKA
82
Error Definition
e
Cod
21 Current
Abnormality
22 Throttle
Abnormality
23 Motor Abnormality
24 Motor Hall Signal
Abnormality
25 Brake Abnormality
30 Communication
Abnormality
General Setting
When the display power on, press both
display is on status of general setting, press the button
Wheel Diameter Setting
Press button or
inch, 18 inch, 20 inch, 22 inch, 24 inch, 26 inch, 700C, 28 inch. Default diameter is 26 inch.
Press button to confirm the value of wheel diameter and enter next setting at the same time.
Speed-limit Setting
Solution
Inspect if motor phrases short-circuits
Inspect if throttle recover original state
Inspect if motor phrase is well-connected;
Inspect if lines are well-connected between
motor phrases and controller
Non-Hall Controller：Inspect if motor phrase
is well-connected;
Hall Controller：Inspect if motor hall is
well-connected.
Inspect if brakes original state before display
start up.
Inspect if lines are well-connected
between display and controller.
and
to select the correct value to match the wheel diameter. Selectable values include: 16
buttons for 2 seconds to enter the setting menu. When the
for 2 seconds to quit setting menu.