Fisher & Paykel AquaSmart WL4027P Instructions D'installation Et Guide D'utilisation page 43

Out of balance (OOB) recovery routine
When your washer is spinning it can sense if the wash load is out of balance. If an out of balance
load is detected, the washer will stop and retry spinning one more time. If it still senses an
unbalanced load there are two options the washer can take.
Automatic recovery OFF (default setting)
Your washer will stop, beep, and show
You must redistribute the load more evenly yourself and touch START/PAUSE to resume the cycle.
Use this option if you wish to conserve water.
Automatic recovery ON
Your washer will try to automatically correct the out of balance load. The machine will fill with
water and agitate to redistribute the load before trying to spin up again.
The washer will compensate for any out of balance by reducing the spin speed. As a result, your
clothes may be wetter than you expect at the end of the cycle.
To change the out of balance recovery routine:
Enter Option Adjustment mode (refer to page 38).
1
For the WL4027P model: select the DELICATE cycle.
2
For the WL4027G model: select the HEAVY cycle.
Touch the MORE
3
Wash Temp
OOB Recovery
Fig.31 Changing the out of balance recovery routine
End of cycle (EOC) beeps
The beeps signalling the end of the cycle can be increased or decreased. The default setting is
5 beeps.
To modify the number of beeps sounding at the end of the cycle:
Enter Option Adjustment mode (refer to page 38).
1
For the WL4027P model: select the SHEETS cycle.
2
For the WL4027G model: select the BULKY cycle.
Touch the MORE
3
beeps, or for no beeps to sound at the end of the cycle.
Wash Temp
OOB Recovery
Fig.32 Modifying the number of beeps to signal the end of the cycle
button to turn automatic out of balance recovery on or off.
EOC Beeps
Factory Reset
or LESS button (where available) to increase or decrease the number of
EOC Beeps
Factory Reset
Changing pre-set options
in three phases on the display screen.
Wash OOB Factory
Temp Recovery Reset
EOC
Beeps
Wash OOB Factory
Temp Recovery Reset
EOC
Beeps
US
41
CA