Fisher & Paykel AquaSmart WL4027P Instructions D'installation Et Guide D'utilisation page 42

Changing pre-set options
US
40
CA
Wash temperature
Controlled Cold
If your incoming cold water temperature is very low you will get a less effective wash. The
CONTROLLED COLD option solves this problem by adding a small amount of hot water to raise
the temperature of the wash to approximately 68°F (20°C).
To program the CONTROLLED COLD temperature option:
Enter Option Adjustment mode (refer to page 38).
1
For the WL4027P model: select the HEAVY cycle (Fig.29).
2
For the WL4027G model: select the REGULAR cycle (Fig.30).
Select COLD wash temperature by using the WASH TEMP button (if not already selected).
3
The digital display shows the temperature adjustment possible. The default setting is
4
ie the temperature of the incoming water from the cold cylinder (tank).
Touch the MORE
■ ■
temperature to approximately 68°F (20°C).
Wash Temp
Fig.29 Changing the Cold wash temperature setting to Controlled Cold (WL4027P)
Wash OOB
Temp Recovery
EOC
Beeps
Fig.30 Changing the Cold wash temperature setting to Controlled Cold (WL4027G)
Note: if you always use COLD or CONTROLLED COLD water, we recommend that a WARM or
HOT wash be used regularly, eg every 5th wash should be at least a warm one to maintain the
cleanliness of your washer.
button so
OOB Recovery
EOC Beeps
Factory Reset
Factory
Reset
or is displayed. Your washer will now control the cold
Wash
Temp Recovery
EOC
Beeps
Wash Temp
OOB Recovery
EOC Beeps
Factory Reset
OOB Factory
Reset
,